1- attached breadboard mount to acrylic and soldered wires to breadboard. I switched the plastic LED bevels to a smaller size so that the LEDs would be more secure in their foam core face.
2- after checking that every set of wires could successfully light an LED with crocodile clamps, I began to solder. Here is me checking that my first two soldered LEDs work.
3- I finished soldering all the LEDs and attached the breadboard to the mount I made. I also fed my measured lengths of power and ground wire through the drill pressed hole and soldered them to the breadboard.
4- Finally, I popped all of the LEDs into the bevels and closed the case.
I love your intricate work on the soldering of wires. I know I had a lot of soldering to accomplish, so it’s nice to see how you approached the task differently.